Drive-By-Wire
Revision as of 04:00, 19 June 2026 by Elcanoadmin (talk | contribs)
Version 5 of the Drive-by-Wire Printed Circuit Board holds five external modules.
1) Arduino Due - underneath the PCB
2} Arduino Motor Shield - on top
3) Real Time Clock - upper right
4) SD card - lower right
5) RC receiver - Lower right corner
A buck converter steps the 24V used for the brakes down to 12V, and passes the 12V (along with CAN HI, CAN LO and ground) to the Navigation computer.
The Drive By Wire PCB with buck converter.
